User's Manual

-58-
Hex 1D 56 m
Decimal 29 86 m
②ASCII GS V m n
Hex 1D 56 m n
Decimal 29 86 m n
[Range] ① m =1,49
② m = 66, 0 ≤ n ≤ 255
[Description] Selects a mode for cutting paper and executes paper cutting. The value of m
selects the mode as follows:
m Print mode
0, 1, 49 Partial cut (one point left uncut)
66 Feeds paper (cutting position + [ n ╳ (vertical motion unit)]), and cuts the paper
partially (one point left uncut).
[Details for ① and ②]
• This command is effective only processed at the beginning of a line.
[Details for ①] • Only the partial cut is available; there is no full cut.
[Details for ②] • When n = 0, the printer feeds the paper to the cutting position and cuts it.
• When n = 0, the printer feeds the paper to (cutting position + [ n ╳ vertical
motion unit]) and cuts it.
• The horizontal and vertical motion unit are specified by GS P.
• The paper feed amount is calculated using the vertical motion unit (y).
However, the value cannot be less than the minimum horizontal movement
amount, and it must be in even units of the minimum horizontal movement
amount.
GS W nL nH
[Name] Set printing area width
[Format] ASCII GS W nL nH
Hex 1D 57 nL nH
Decimal 29 87 nL nH
[Range] 0 ≤ nL ≤ 255
0 ≤ nH ≤ 255
[Description] Sets the printing area width to the area specified by nL and nH.
• The printing area width is set to [( nL + nH ╳ 256) ╳horizontal motion unit]]
inches.
[Details] • This command is effective only processed at the beginning of the line.
• In page mode, the printer performs only internal flag operations.
• This command does not affect printing in page mode.
• If the [left margin + printing area width] exceeds the printable area, [printable
area width - left margin) is used.
• The horizontal and vertical motion units are specified by GS P. Changing the