User's Manual

-54-

0 ≤ d ≤ 255

[Description] Defines a downloaded bit image using the number of dots specified by x and y

• x specifies the number of dots in the horizontal direction.

• y specifies the number of dots in the vertical direction.

[Details] • The number of dots in the horizontal direction is x

╳

8, in the vertical direction it

is y

╳

• If x

╳

y is out of the specified range, this command is disabled.

• The d indicates bit-image data. Data ( d) specifies a bit printed to 1 and not

printed to 0.

• The downloaded bit image definition is cleared when:

① ESC @ is executed.

② ESC & is executed.

③ FS q is executed.

④ Printer is reset or the power is turned off.

• The following figure shows the relationship between the downloaded bit image

and the printed data.

[Reference] GS /

GS / m

[Name] Print downloaded bit image

[Format] ASCII GS / m

Hex 1D 2F m

Decimal 29 47 m

[Range] 0 ≤ m ≤ 3, 48 ≤ m ≤ 51

[Description] Prints a downloaded bit image using the mode specified by m.

m selects a mode from the table below:

m Mode Vertical Dot Density (DPI) Horizontal Dot Density (DPI)

0, 48 Normal 200 200

1, 49 Double-width 200 100

2, 50 Double-height 100 200

3, 51 Quadruple 100 100

[Details] • This command is ignored if a downloaded bit image has not been defined.

• In standard mode, this command is effective only when there is no data in the