User's Manual

-46-
On 02 2 Paper roll near-end sensor enabled
2-7 - - - Undefined
[Details] · When a paper sensor is enabled with this command, printing is stopped only when the
corresponding paper is selected for printing.
· When a paper-end is detected by the paper roll sensor, the printer goes offline after
printing stops.
· When either bit 0 or 1 is on, the printer selects the paper roll near-end sensor for the
paper sensor to stop printing.
[Default] n = 0
ESC C 5 n
[Name] Enable/disable panel buttons
[Format] ASCII ESC c 5 n
Hex 1B 63 35 n
Decimal 27 99 53 n
[Range] 0 ≤ n ≤ 255
[Description] Enables or disables the panel buttons.
• When the LSB of n is 0, the panel buttons are enabled.
• When the LSB of n is 1, the panel buttons are disabled.
[Details] • Only the lowest bit of n is valid.
• When the panel buttons are disabled, none of them are usable when the printer
cover is closed.
• In this printer, the panel buttons are the FEED button.
• In the macro ready mode, the FEED button are enabled regardless of the
settings of this command; however, the paper cannot be fed by using these
buttons.
[Default] n = 0
ESC d n
[Name] Print and feed n lines
[Format] ASCII ESC d n
Hex 1B 64 n
Decimal 27 100 n
[Range] 0 ≤ n ≤ 255
[Description] Prints the data in the print buffer and feeds n lines.
[Details] • This command sets the print starting position to the beginning of the line.
• This command does not affect the line spacing set by ESC 2 or ESC 3.
• The maximum paper feed amount is 1016 mm (40 inches). If the paper feed
amount ( nx line spacing) of more than 1016 mm (40 inches) is specified, the
printer feeds the paper only 1016 mm (40 inches).
[Reference] ESC 2, ESC 3
ESC p m t1 t2
[Name] Generate pulse
[Format] ASCII ESC p m t1 t2
Hex 1B 70 m t1 t2
Decimal 27 112 m t1 t2
[Range] m = 0, 1, 48, 49