User's Manual

-45-
[Name] Select paper sensor(s) to output paper end signals
[Format] ASCII ESC c 3 n
Hex 1B 63 33 n
Decimal 27 99 51 n
[Range] 0 £ n £ 255
[Description] Selects the paper sensor(s) to output paper end signals
· Each bit of n is used as follows:
Bit Off/On Hex Decimal Function
Off 00 0 Paper roll near-end sensor disabled
0
On 01 1 Paper roll near-end sensor enabled
Off 00 0 Paper roll end sensor disabled
1
On 02 2 Paper roll near-end sensor enabled
Off 00 0 Paper roll end sensor disabled
2
On 04 4 Paper roll near-end sensor enabled
Off 00 0 Paper roll end sensor disabled
3
On 08 8 Paper roll near-end sensor enabled
4-7 - - - Undefined
[Details] · It is possible to select multiple sensors to output signals. Then, if any of the sensors
detects a paper end, the paper end signal is output.
· The command is available only with a parallel interface and is ignored with a serial
interface.
· Sensor is switched when executing this command. The paper end signal switching
be delayed depending on the receive buffer state.
· If either bit 0 or bit 1 is on, the paper roll near-end sensor is selected as the paper
sensor outputting paper-end signals
· If either bit 2 or bit 3 is on, the paper roll end sensor is selected as the paper sensor
outputting paper-end signals.
· When all the sensors are disabled, the paper end signal always outputs a paper
present status.
ESC c 4 n (*)
[Name] Select paper sensor(s) to stop printing
[Format] ASCII ESC c 4 n
Hex 1B 63 34 n
Decimal 27 99 52 n
[Range] 0 £ n £255
[Description] Selects the paper sensor(s) used to stop printing when a paper-end is detected,
using n as follows:
Bit Off/On Hex Decimal Function
Off 00 0 Paper roll near-end sensor disabled
0
On 01 1 Paper roll near-end sensor enabled
1 Off 00 0 Paper roll end sensor disabled