User's Manual

-37-
• When setting n = 8, the print position is moved to column 9 by sending HT.
• Up to 32 tab positions ( k = 32) can be set. Data exceeding 32 tab positions is
processed as normal data.
• Transmit [ n] k in ascending order and place a NUL code 0 at the end.
• When [ n] k is less than or equal to the preceding value [ n] k-1, tab setting is
finished and the following data is processed as normal data.
• ESC D NUL cancels all horizontal tab positions.
• The previously specified horizontal tab positions do not change, even if the
character width changes.
• The character width is memorized for each standard and page mode.
[Default] The default tab positions are at intervals of 8 characters (columns 9, 17, 25,...) for
font A (12 ╳24).
[Reference] HT
ESC E n
[Name] Turn emphasized mode on/off
[Format] ASCII ESC E n
Hex 1B 45 n
Decimal 27 69 n
[Range] 0 n 255 
[Description] Turns emphasized mode on or off
• When the LSB of n is 0, emphasized mode is turned off.
• When the LSB of n is 1, emphasized mode is turned on.
[Details] • Only the least significant bit of n is enabled.
• This command and ESC ! turn on and off emphasized mode in the same way.
Be careful when this command is used with ESC !.
[Default] n = 0
[Reference] ESC !
ESC G n
[Name] Turn on/off double-strike mode
[Format] ASCII ESC G n
Hex 1B 47 n
Decimal 27 71 n
[Range] 0 ≤ n ≤ 255
[Description] Turns double-strike mode on or off.
• When the LSB of n is 0, double-strike mode is turned off.
• When the LSB of n is 1, double-strike mode is turned on.
[Details] • Only the lowest bit of n is enabled.
• Printer output is the same in double-strike mode and in emphasized mode.
[Default] n = 0
[Reference] ESC E
ESC J n
[Name] Print and feed paper
[Format] ASCII ESC J n
Hex 1B 4A n