User's Manual
Step 3: Choose the method of camera network configuration.
1. Through a QR code
① After entering the WiFi network setting interface, the APP will display name
of the WiFi network connected because your mobile phone has connected to
the WiFi network of your home. Just enter the WiFi password and confirm it
and then click “QR code configuration”. (Fig. 7)
② The APP will generate a QR code automatically. Have the QR code on your
mobile phone point at the lens of the camera (distance: about 15cm) for
identification. When there is a prompt tone given by the camera, it suggests
that the QR code scanning has succeeded and the camera has been
connected to the APP automatically.
Note: If camera connection fails, try as below.
1. Check the battery level of the camera is sufficient, power on the camera,
press and hold the reset button for 10 seconds and then release it for camera
connection.
2. Through a sound wave
① After entering the WiFi network setting interface, the APP will display name
of the WiFi network connected because your mobile phone has connected to
the WiFi network of your home. Just enter the WiFi password and confirm it
and then click “Sound wave configuration”.(Fig. 7)
② The APP on our mobile phone will then send a sound wave automatically
(you can volume up your mobile phone for better configuration). Put your
mobile phone by the camera for sake of its reading. When there is a prompt
tone given by the camera, it suggests that the sound wave reading has
succeeded and the camera has been connected to the APP automatically.
-04-