Specifications

TURNTABLE PARTS
GETTING STARTED
1. 45RPM adaptor
2. Lift lever
3. AUTO-STOP ON/OFF switch
4. Speed switch
5. Tonearm
6. Tonearm lock
7. Cartridge with needle
8. Platter
9. Status indicator
10. 3.5mm headphone jack
11. Power ON/OFF and volume control knob
12. RCA out port---to connect external
speaker system with built-in amplifier
13. Line in(AUX-IN) port
14. DC IN jack—to connect the power
adaptor
Firmly and securely insert the DC plug of the adaptor to the DC IN Jack on the unit.
Insert the adaptor’s AC plugs into a power outlet.
BEFORE USE
1. Choose a safe location and avoid placing the unit in direct sunlight or near any
heat source.
2. Avoid locations subject to vibrations, excessive dust, cold, or moisture.
3. Do not open the cabinet as this may result in an electrical shock. If a foreign object is
inserted accidentally contact your dealer.
4. Do not attempt to clean the unit with chemical solvents as this might damage the
finishing. A clean, dry cloth is recommended for cleaning.
5. Keep this manual for future reference.
PARAMETER SPECIFICATION
BLUETOOTH MODE
1.Turn on the power switch knob. The device enters into Bluetooth mode automatically
(USB,AUX-IN ports is not occupied)The status indicator will become blue with flashing.
2.Turn on the Bluetooth function on your mobile phone or tablet PC and search device
name ANESOK-A6. After pairing and connection, the indicator will become blue without
flashing, then you can play your music from your mobile phone or tablet PC through this
turntable player. Turn the VOLUME CONTROL KNOB to adjust the volume. The mobile phone
or tablet PC’s volume control also impacts the overall volume level. Please adjust that as
well if necessary.
TIPS FOR BETTER TURNTABLE PERFORMANCE
1. When opening or closing the turntable cover, handle it gently, gripping it either at the
centre or at each side.
2. Do not touch the needle tip with your fingers; avoid bumping the needle against the
turntable platter or record edge.
3. Frequently clean the needle tip-use a soft brush in a “back-to-front’ motion only.
4. If you must use a needle cleaning fluid, use it very sparingly..
5. Gently wipe the turntable player housing with a soft cloth. Use only a small amount of
mild detergent to clean the turntable player.
6. Never apply harsh chemicals or solvents to any part of the turntable system.
NOTES
1. We recommend that you clean your turntable with an anti-static cloth for maximum
protection.
2. We would also point out that for the same reason your stylus should be replaced
periodically (approximately every 250 playback hours)
HOW TO REPLACE THE NEEDLE
To replace the needle, please refer to the instructions below.
Removing the needle from the cartridge:
1.Place a screwdriver at the tip of the stylus and push downward as shown in direction “A”.
2. Remove the stylus by pulling the stylus forward and pushing downward.
Installing the Stylus:
1.Hold the tip of the stylus and insert the stylus by pressing as shown in direction “B”.
2. Push the stylus upward as in direction "C" until the stylus locks into the tip
position.
3. Turn the VOLUME CONTROL KNOB to adjust the volume. The iPod, MP3 player, mobile
phones’ volume control also impact the overall volume level. Please adjust that as well if
necessary.
AUX IN MODE
1. AUX-IN mode is precedence after plugin, plug 3.5mm Audio cable, Device
enter into AUX-IN mode automatically.
2. You can enjoy the music from iPod, MP3 player, mobile phones, etc. through the record
player.
AMPLIFIER CONNECTION (IF REQUIRED)
Whilst you can listen to your new turntable using the built in speakers you may
wish to connect it to your existing Hi-Fi system. Connect the audio plugs to the
Line input on your mixer or amplifier using an RCA cable (not supplied)
● Red plug into R/H channel input.
● White plug into L/H channel input.
PHONO MODE
1. Turn on the power switch knob.
2. Place a record on the turntable platter and select the desired speed (33/45/78)
according to the record. NOTE: when playing a 45RPM record, use the included 45RPM
adapter located in the holder near the tonearm.
3. Remove the white needle protector and open the tonearm clip to release the tonearm.
Push the lift lever backward to raise the tonearm and gently move the tonearm towards
the desired position over the record. Push the lift lever forward to lower the tonearm slowly
onto the desired position on the record, Device enters into PHONO mode automatically to
begin playing the record.
4.If the AUTO STOP ON/OFF Switch is turned ON, the record will stop playing automatically
when finished (For a few vinyl records, it will stop when it does not come to the end OR it
will not stop when it comes to the end.). If Auto Stop Control is turned OFF, the record will
NOT stop playing automatically when finished.
Notice: PHONO mode is the highest precedence, must stop PHONO mode to switch into
BT, AUX, USB mode.
Model
Input voltage
Power Adapter
Product Dimensions
Item Weight
Bluetooth
Play mode
Rotational speed
Record size
Power cord length
A6
AC100V~240V
50/60HZ
DC12V/1.0A
36.8*33*13.6 cm
2.35 kg
V 5.1
LP/Bluetooth/AUX
33/45/78 RPM
7/10/12
1 m
1
2
8
7
3
9
10
4
11
5
6
FUNCTION DESCRIPTION
FUNCTION DESCRIPTION
FUNCTION DESCRIPTION FUNCTION DESCRIPTION
1312 14
EN

A vinyl record player
A6