User's Manual

The power cable connector is damaged.
There is liquid inflow inside the device;
The equipment has been exposed to humid environments;
The device is dropped or damaged;
The device has obvious appearance damage.
Disclaimer: This safety directive complies with the requirements of
IEC 704-1. Shenzhen Zhilai Sci and Tech Co., Ltd. does not assume any
legal responsibility for the accuracy of its contents.
Safety measures - electrostatic protection
To ensure that you and your equipment are not harmed or damaged,
please observe the following safety precautions:
Do not touch the device in the device before operating the device
to avoid electric shock.
Do not touch the CPU and other key components directly with your hands
to avoid damage to critical components caused by static electricity;
Before installing the device, please ensure that the installer
ensures that the static electricity is attached to the body. For safety
reasons, use a grounded static wrist ring.
目录 Contents
1、 概述 .................................................................................................................................................. 1
1.1、 产品简介.............................................................................................................................. 1
1.2 、硬件规格.............................................................................................................................. 2
1.2.1 一般描述 ................................................................................................................... 2
1.2.2 系统硬件 ................................................................................................................... 2
1.2.3 I/0 接口 .................................................................................................................... 3
1.2.4 环境规格 ................................................................................................................... 3
1.3 、安全措施.............................................................................................................................. 3
1.4、产品尺寸................................................................................................................................ 3
1.4.1 产品三维外观图 ....................................................................................................... 3
1.4.2 产品尺寸图 ............................................................................................................... 4
2、 接口说明 .......................................................................................................................................... 5