Users Manual

PAIRING MODE
The headphones and the transmitter enclosed
in this package have been paired from the factory .
To enter pairing mode:
1 .Connect the audio transmitter to a power
source and turn the headphones on .
2. Locate the DSP SELECT SWITCH on the
headphones ,and press it for more than 3 seconds .
PAIRING BUTTON
The Status LED on the headphones will be flashing .
3. Locate the Pairing button on the bottom of the
transmitter,and press it for more than 3 seconds .
The POWER/CHARGING INDICATOR on the
transmitter will be flashing .
4. When green LED on the transmitter and the
blue LED on the headphones become steady
simultaneously,it means paired successfully.
NOTE: When your devices are paired there
will be a short beep in the headphones .
DSP SELECT SWITCH
SPECIFICATION
Transmission mode : Digital Hopping System
Carrier frequency : 2.4GHz
Operating voltage : Transmitter 5V
Built-in 400 mAh lithium battery
Frequency response : 20 Hz-20 KHz
Work Time : 8 hours
Charge Time : 1.5-2.0 hours
Distortion : 0.5%
Signal- to- noise ratio : 85 dB
Range : > 30 meters
DSP : original sound /musicalmode / film mode
Standby : ≤ 0.5W