User Manual
8 9
Locate the power button on
and press it for 3 seconds to power
on the scooter. You should now be
able to see the display powered
on. Keep the scooter elevated on
the stool or bench, as the testing
will involve spinning both wheels.
The scooter should be in Kick to
Start mode, to begin testing the
motors, spin the wheel and then
press the throttle. The wheels
should begin to spin normally. You
may notice either motor emitting a
noise at low speeds, this is normal.
The motor is communicating with
Begin by testing your brakes.
Press the throttle on the right
side of your handlebar and notice
both wheels start to accelerate.
Continue to accelerate for 5
seconds, then release the throttle
and slam both brakes at the same
time. The wheel should stop
immediately.
Test gear change by pressing
the Power Button. A short
click will change the speed levels.
t 1 click – Eco mode
t 2 clicks – Comfort mode –
a second click you should see a
Green "S" on the display
t 3 clicks – Sport mode – another
short click should display a Red
"S".
To read more about the speed of each mode,
refer to the Diplay section in this manual.
Perform test
1
2
3
4
1 2 3 4
the controller and identifying its
position as well as which direction
test the wheels are spinning nor-
mally, you can now move to step 2.
If you notice one of the motors is not spin-
ning PLEASE DO NOT ATTEMPT TO OPERATE
THE SCOOTER. Contact us immediately
through our help desk apolloscooters.co/
support.
Next, grab an air pump and
locate the air valve on the
front tire. Remove the safety cap
and attach the pump tube to the
tire valve. Turn on the air pump and
read the PSI measure - the ideal tire
pressure for the City is 45PSI.
Inflate or deflate the tire as
needed until the pressure
is 45PSI. Repeat the step with the
rear tire.
Next, to turn on the lights
press the Mode button (M).
Confirm all of the lights power on:
headlight and one rear tail light.
If all of the lights do not power on, DO NOT
ATTEMPT TO OPERATE THE SCOOTER.
Contact us immediately via our help desk
apolloscooters.co/support .
signals. Start by testing your
right signal by pressing the button
with an arrow on the right side of
your handle bar. Your right signals
should turn on. To turn them o,
click on the button again.
side of the handle bar. Your signals
should turn on. To turn them o,
click on the button again.
4 5
6
7
8
5 6 7 8
Congratulations, you have success-
fully set up your new Apollo City.
If you experience diculties with the setup
at any step, please refer to our help centre at
apolloscooters.co/support for a video walk-
through of the process. Alternatively, you
can contact our support team at support@
apolloscooters.co for assistance.