User Manual

6 7
The first step is to unfold your
Apollo City. To do so, ensure
the hook is not clipped into the
rear foot rest. If it is, push down on
the stem and unhook it from the
rear foot rest.
Unfold the stem by pulling it
to a vertical position. Ensure
you do so until the stem is com-
pletely vertical.
Locate the folding latch and
bring it up, locking the stem.
The latch will require some force to
lock fully upright.
Lastly, make sure the safety
button of the folding mech-
anism is clipped in the stem. This
safety mechanism prevents the
latch from unlocking due to vibra-
tion or shock.
Prepare for assembly
Unfolding
1 2
3 4
1
2
3
4
Connect the male connection cable coming out of
the handlebar into the female cable coming out of
the front stem. Make sure the pins are aligned.
Make sure the male port and the female port are
aligned properly. Insert the handlebar at the top of
the front stem and tighten into place with the hex
screw provided.
Caution: Be careful not to damage the cable when
connecting the handlebar to the front stem.
You will find that the latches and buttons on your
handlebar are not tight. We deliver this way to
avoid damage during shipping. Before tightening
upward or downward until it reaches a comfort-
able angle, keep in mind that once on a scooter,
you will be higher up than you are while setting up
your scooter. When you have found a comfortable
position, go ahead and tighten the screws.
Repeat the same process for the screws on the
right hand side of your handlebar.
Attach handlebar
1
3
5
2
4
1
2
3
4
5
scooter