User Manual

8 9
Turn on the scooter by pressing on the
power button located at the bottom of the
display. To turn it on press the button from 2 to 3
seconds, until you hear a beep.
The speedometer, speed units, and the battery
level should now be visibile on the display.
Now test your brakes — Press the throttle
on the right side of your handlebar and
notice both wheels start to accelerate. Continue
to accelerate for 5 seconds, then release the
throttle and slam your brakes at the same time.
The wheel should stop immediately.
Check that the gear change function is
working properly by pressing shortly on
the power button again.
A green "S" should now be visible on the
display, a third press should make the "S" turn to
red, changing to the top speed gear.
To learn more about the speed of each gear
refer to the display section in this manual.
Next, grab an air pump and locate the air
valve on the front tire. Remove the safety
cap and attach the pump tube to the tire valve.
Turn on the air pump and read the PSI measure
— the ideal tire pressure for the Air is 36PSI.
1
32
4
Inflate or deflate the tire as needed until
the pressure is 36PSI. Repeat the step with
the rear tire.
5
Congratulations, you have successfully set up
your new Apollo Air.
If you experience diculties with the setup at any step, please
refer to our help centre at apolloscooters.co/support for
a video walkthrough of the process. Alternatively, you can
contact our support team at [e-mail] for
assistance.
TESTING
Electric Scooter