User's Manual

memory card when it is turned on. When you want to listen to the songs from the mobile phone,
you must switch to the Bluetooth mode).
Swit
ch Chinese and English prompt tone: after it is connected, double-click the volume+ button
twice to switch to Bluetooth pairing mode, and then press the power button twice before
connecting.
2.
Bluetooth pairing instructions
Press and hold the power button for 5 seconds until the led indicator flashes red and blue
alternatively. It means the headphones enter the pairing mode. Turn on the Bluetooth function of
the mobile phone (or the device enabled Bluetooth function) and search the pairing
Name:"Regular". The mobile phone(and the device with Bluetooth function)can be connected
successfully by clicking pairing. After the first pairing is completed successfully, the subsequent
boot will automatically connect the last paired mobile phone (or the device with Bluetooth
function) only if the Bluetooth of the mobile phone(and devices with Bluetooth function) is
turned on.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
This device may not cause harmful interference, and
This device must accept any interference received, including interference that may cause
undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF warning statement:
- The device has been evaluated to meet general RF exposure requirement. The device can be
used in portable exposure condition without restriction.