User's Manual

P35 Virtual AP

2.4G Access Control: Mainly show MAC allow or deny:

P36 MAC Access Control

2.4G Advanced Settings:

In this page, will show the regional, RF Power, Max user access...

PAGE 1
P35 Virtual AP 2.4G Access Control: Mainly show MAC allow or deny: P36 MAC Access Control 2.4G Advanced Settings: In this page, will show the regional, RF Power, Max user access...
PAGE 2
P37 Advanced Setting 5.8G Wireless Setting: Almost same as 2.4G Wireless: P38 5.
PAGE 3
P39 Network Setting
PAGE 4
P40 Tag VLAN Setting Management: In this part, show the system time, Logs, upgrade firmware, system, user info.
PAGE 5
P43 System info 4th Share Internet and Obtain IP address automatically Set computer’s TPC/IP as Obtain an IP address automatically, Obtain DNS server address automatically as following picture showed. the computer will obtain the IP address from router or base station to get Internet.
PAGE 6
F 1 The Failure phenomenon and solution Failure phenomenon SYS Indicator off Can’t land to Wireless AP through Web page Wireless AP can’t connect with AP （the status display unconnected） Can’t scan the wireless AP The connection of Wireless AP and AP is success, but the computer can’t share internet How to Reset Wireless AP Solution Pls make sure the PoE module connection is right.