User Manual

Please install the silicone cover for the charging stand on the surface of the wireless charger and
plug the USB cable of the charging stand into the USB jack of the charger or electronic device.
Just place the Y2087 in the slot in the middle of the silicone sleeve and the handle shows
charging.
1. Do not disassemble, hit, squeeze or put into the fire
2. Do not place in high temperature environment
3. Prohibit the use of the product after immersion in water
4. Prohibit the placement of any metal outside the toothbrush on the charger
5. If the product is overheated when charging, please immediately unplug the power and stop
using
Important Tips for Charging
This product uses wireless charging mechanism, it is recommended to place this product on the
wireless charger only when charging is required/needed. When charging is not required/needed,
please place the toothbrush elsewhere. (As shown in the picture) Placing the toothbrush on the
energized wireless charging base for a long time may lead to premature decay of the built-in
battery and affect the usage experience.
Clean The Charger
Before cleaning the charger, be sure to unplug it from the outlet and it is recommended to use a
dry soft cloth to wipe the surface of the wireless charger. After cleaning, you need to/please wait
until the charger is thoroughly dry before putting it into use.
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety.
Children should be supervised to ensure that they do not play with the appliance.
The instructions for class III appliances shall state that it must only be supplied at safety
Extra low voltage corresponding to the marking on the appliance.
Product Specifications
Product Name: Wireless Charger
Model: WP01
Output Power: 1.5W
Input: 5V/1A
Work temperature：-20-40℃