Installation Instructions

FCC Warning
This device complies with
Part 15 of the FCC Rules.
Operation is subject to the
following two conditions:
(1) This device may not cause
harmful interference, and (2)
this device must accept any
interference received,
including interference that
may cause undesired
operation.
NOTE 1: This equipment has
been tested and found to
comply with the limits for a
Class B digital device,
pursuant to part 15 of the FCC
Rules. These limits are
designed to provide
reasonable protection against
harmful interference in a
residential installation. This
equipment generates uses and
can radiate radio frequency
energy and, if not installed
and used in accordance with
the instructions, may cause
harmful interference to radio
communications. However,
there is no guarantee that
interference will not occur in a
particular installation. If this
equipment does cause harmful
interference to radio or
television reception, which
can be determined by turning
the equipment off and on, the
user is encouraged to try to
correct the interference by one
or more of the following
measures:
- Reorient or relocate the
receiving antenna.
- Increase the separation
between the equipment and
receiver.
-Connect the equipment into
an outlet on a circuit different
from that to which the
receiver is connected.
-Consult the dealer or an
experienced radio/TV
technician for help.
NOTE 2: Any changes or
modifications to this unit not
expressly approved by the
party responsible for
compliance could void the
user's authority to operate the
equipment.