Users Manual
Table Of Contents
- USER MANUAL_页面_36
- USER MANUAL_页面_37
- USER MANUAL_页面_38
- USER MANUAL_页面_39
- USER MANUAL_页面_40
- USER MANUAL_页面_41
- USER MANUAL_页面_42
- USER MANUAL_页面_43
- USER MANUAL_页面_44
- USER MANUAL_页面_45
- USER MANUAL_页面_46
- USER MANUAL_页面_47
- USER MANUAL_页面_48
- USER MANUAL_页面_49
- USER MANUAL_页面_50
- USER MANUAL_页面_51
- USER MANUAL_页面_52
- USER MANUAL_页面_53
- USER MANUAL_页面_54
- USER MANUAL_页面_55
- USER MANUAL_页面_56
- USER MANUAL_页面_57
- USER MANUAL_页面_58
- USER MANUAL_页面_59
- USER MANUAL_页面_60
- USER MANUAL_页面_61
- USER MANUAL_页面_62
- USER MANUAL_页面_63
- USER MANUAL_页面_64
- USER MANUAL_页面_65
- USER MANUAL_页面_66
- USER MANUAL_页面_67
- USER MANUAL_页面_68
- USER MANUAL_页面_69
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may cause
undesired operation.
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.