Installation Instructions

95*65mm 双色印刷 80G书写纸
折页形式
This device complies with part 15 of the FCC Rules. Operation is subject to
thefollowing two conditions: (1) This device may not cause harmful
interference, and (2)this device must accept any interference received,
including interference that maycause undesired operation.
Any Changes or modifications not expressly approved by the party
responsible forcompliance could void the user's authority to operate the
equipment.
Note: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate
radio frequency energy, and if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
$7:*$($
