User's Manual

Table Of Contents

4.Channel Setting：

Long press the [ZOOM/CH] button, then press the [UP] or

[RIGHT] for increasing, press the [DOWN] or [LEFT] for

decreasing, press [OK] for confirm. Set the same channel

as the YN-622N transceiver.

5. ：

1).

2).

*For non-i-TLL

flash mode or other triggering mode, refer to P.12).

Transceiver and Flash Settings

Set the transceiver’s receiving group, and set the same

channel as the YN-622N-TX controller.

Set the flash to i-TTL flash mode*, the flash will fire

according to the flash mode and parameters set by the

controller, support i -TTL/manual flash. (

Preparation Before Use