User's Manual

2.PC & Basic flash Trigger(Support non Nikon body)
PC (input) Use LS-PC/PC cable (option)to
connect the controller and the PC interface of camera.
Basic flash (Single Contact) trigger: Install the controller
on the camera hot shoe.
interface
interface trigger:
1).Transmitting group setup: Group setup according to the
controller.
2).Flash mode setup: Set the manual flash(M) mode through
the flash control panel, change the flash output manually, use
the controller PC interface or main flash contact trigger, not
support high speed sync or other TTL function (the highest
synchronous speed is 1/250s or lower).
Set the compatible flash on the transceiver to Manual or RPT
flash mode, the flash will work according to the mode and
parameters displayed, the controller will not support the remote
controlling the flash mode or flash exposure compensation (flash
output).
The other Trigger Modes
1.Non-Remote Control Mode: