User's Manual

1.Set the time delay parameter of controller SS:
Long press the [AF/SS] button to proceed setting, press the
[UP][DOWN][LEFT][RIGHT] button to adjust, press [OK] to
confirm and exit setup, supports Automatic Setup (AU) or Manual
Setup 0.1-3.0.
Using Super Sync:
1).Set the flash in manual mode, Support transceiver using hot
shoe flash or connecting to the PC port . and it may needs
setting at manual full-power flash output (1/1).
According to the flash model, output power and shutter speed
to adjust controller “SS” to a suitable time delay parameters.
2.
2).Set the flash sync speed of the camera as AUTO FP, the
maximum shutter sync speeds can reach to 1/8000s.
3).Take photos and check whether the photos are synchronous ,
it may see gradations or variations in the photos, results
depend on the camera and flash.
2.
Use the non-high speed sync
flash to realize higher sync speed,
this function is more applicable to
strobe flashes whose flash duration
is longer, and it is for the camera
w h i c h s u p p o r t A u t o F P o n l y.
S u p p o r t
About the Super Sync(SS)
s e t u p t h e t i m e d e l a y
parameter of Super Sync.
Setting