User's Manual

1) .P r es s th e [G RO U P ] b ut to n to
choose the setup group, press with
the arrow to select A/B/C group.
2).Press the [MODE] button to set the
flash mode of selected group, each
press for the settings as below:
TTL: i-TTL Flash, the FEC adjustment range is within -3-
+3EV, press [LEFT] or [RIGHT] button to increase and
reduce 1EV, press [UP] or [RIGHT] button to increase and
reduce 0.3EV.
M: Manual Flash, The adjustment range is within 1/128-1/1,
press [LEFT] or [RIGHT] button to adjust, press the [UP] or
[RIGHT] button for fine adjustment.
SS: (Super Sync, refer to Page 9)
(None):The group is not participate in flash.

It is supported to set the FEC on the flash
directly, the compensation value shall be superposed
according to flash setting plus the controller setting.
When setting the flash mode and parameters on the
controller, the screen of the flash on the transceiver will
not change.
1. Groups and Modes Setting(Remote Control)
Setting
Shooting with a Different Flash Mode for Each Group