User's Manual

6. The assist beam emitter doesn't work: Refer to page 24.
7. The on-top flash doesn't fire: Enabled the master flash via
the wireless function setting.
8. Can't set the flash zoom via camera menu: W h e n t h e m i x
control mode has been set in the transmitter (p.21) or zoom
locking has been set in the receiver (p.15), zoom can't be set
via camera menu. Zoom setting of the on-top flash needs to
be set separately(p.17).
9. Fail to set channel 5, 6, 7 via camera menu: This is caused by
the camera restriction and it can only set the channel 1-4 in
via camera menu, while other channels can be set via channel
button.
10.ETTL underexposure or overexposure:Suggest enable
wireless flash function when using ETTL flash mode, and
adjust the position of the flash, use FEC/FEL function, check
flash’s effective range. It may overexposure when ETTL and
manual flash are used at the same time, now the manual flash
suits to be used as a backlight.
10.Information of aperture, distance are not displayed on the
flash when half pressing the shutter:Set compatiable flash
mode/shutter sync with the flash on the transmitter.
11.No effect of the flash exposure bracketing calculation on
receiver: Set the flash mode which is compatible with the
flash.
vIt is suggested using the following procedures to deal
with when other trouble occur during the using:
1). Restart all the equipments.
2). Replace the batteries of the transceivers.
3). Reset the factory set of the transceivers/camera/flash.
4). Install the hot-shoe flash on the camera directly and clear the
custom function of external flash then install it on transceiver
again.
Troubleshooting
28