User's Manual

Table Of Contents

Troubleshooting

1. Fail to power on or automatic shutdown:

 The battery is loaded inversely or exhausted;

indicator light will blink(red) separately when the batter y is

going to be exhausted, and it will power off automatically in

case of being over discharged.

▲ Install the battery according to the correct direction, ensure the

battery is full and restart the power (refer to page 8).

2.The flash doesn't fire:

 Ensure the power of all are full, the connection among the

transceiver, camera and the flash is reliable; whether the

indicator is set in the same channels and controllable groups.

Flashes recycle process, entering in the state of overheating

protection, the flash enters into sleep status etc. may makes the

flash doesn't fire. Ensure the flash is in ready state, use the [Test]

button test the flash before using.

Check the power switch of the receiver to see if it set to correct

communication mode. Such as the receiver set to “560-RX”

mode, it will not receive the signal of “622".

3. Fail to enable the 2nd curtain sync:

That’s because the restriction of camera menu.

▲ It shall set the wireless function disabled if needs using the 2nd

curtain sync.

4. Can't access into the external flash function menu or the

menu is displayed abnormally:

The transmitter is not installed right , the contacts of the hot

shoe is stained or the power of the batter y is exhausted.

▲ Reinstall the transmitter and clean the contacts ,replace the

batteries.

5.The channel indicator bright all along, unable to change the

flash mode and zoom of camera menu.

It is because enable the “mix control mode”.

▲ Please long press the “CH SET” button to exit the mix control

mode or restore to factory settings.

the status