User's Manual

25
Reference-About 560-RX
1.Set to the 560-RX mode through the power switch.
2.Set the same channel as the transmitter (Shortly
press the【CH SET】button).
4.Shoot and trigger the flash.
When the power switch set to “560-TX”, it is
recommended only use the YN560-TX/RF603/RF605
as transmitter, the YN622C II as receiver. If it is used
as transmitter in this communication mode, it will
transmit as “622” communication mode.
3.Set the receiving group (press the【GP SET】button).
Ch7
Ch6
Ch5
Ch4
Ch3
Ch2
Ch1
The YN622C II supports receiving the triggering signal
YN560-TX (RF603 communication mode),when using the
compatible flash, it can wireless control the flash mode,
flash output and zoom of each group; meanwhile supports
the triggering signal(the flash set to M mode) of the
RF603(II)、 RF605(RF603 communication mode). Supports
grouping function of the YN560-TX、RF605.