Installation Instructions

FCC Warning
This device complies with part 15 of the FCC rules. Operation is
subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
inte rference received, including interference that may cause
undesired operation.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interferenceto radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
-Reorient or relocate the receiving antenna.
·Increase the separation between the equipment and receiver.
·Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
·Consult the dealer or an experienced radio/TV technician for
help.
Radiation Exposure Statement
To comply with FCC RF exposure compliance requirements,
this grant is applicable to only mobile configurations. The
antennas used for this transmitter must be installed to provide a
separation distance of at least 20cm from all persons and must
not be co-located or operating in conjunction with any other
antenna or transmitter.