User's Manual

20
5 Set up and update
5.1 Mode setting for maximum charging current
（Only for 22KW）
5.2 External enabling/disabling of the Wallbox
5.3 Firmware version upgrade
This product can update the firmware software of the product through the Micro SD Card. The
user puts the firmware that needs to be updated into the Micro SD Card through the computer,
and then powers off the charging station, and inserts the Micro SD Card into the SD card slot
as shown above. Restart the charging station. When the software version in the lower right
corner of the LCD display is updated, it means that the firmware of the charging station has
been updated. Then remove the Micro SD Card.
The Wallbox can be set to plug and play
charging, dial the code switch No. 1
upwards as shown in the picture on the left