Technical Specs

PRELIMINARY OPERATIONS

Connect the cable to the Micro USB socket, and place the smart watch on the wireless

charger. If the watch is on, it indicates that the charging is in progress. At the same

time, you can check the battery charge status on the smart watch screen.

Note: for recharging your Smartwatch, WIRELESS CHARGER must be powered by

an adaptive charger or alternatively a charger with at least a 1A charge.

WIRELESS CHARGER is compatible for use with most of the cases on the market

and charging times may vary depending on the thickness of the case.

Also make sure that there are no metallic or magnetic elements between the

Smartphone and the charger.

TECHNICAL SPECIFICATIONS WIRELESS FAST CHARGER STAND KIT

Input Voltage : DC5V from adapter

Antenna Type : Coil

Frequency band: 320-325 KHz

INFORMATION ON THE STATUTORY WARRANTY

Our products are covered by a statutory warranty against conformity

defects in accordance with applicable national consumer protection

Use the watch charger only as instructed in the packaging Must be

powered using a suitable watch charger

Protect the product from dirt, humidity, overheating and use only in dry

environments, avoiding all contact with liquids

Do not expose to the sun, high temperatures or flames

If the cable is dropped, ensure it is not damaged before using it again

Keep far from the reach of children

Shenzhen Yinai Intelligent Manufacturing Technology

Co., Ltd declares that this wireless charger complies with

Directive 2014/53/EU. Shenzhen Yinai Intelligent

Manufacturing Technology Co., Ltd also declares that

this wireless charger complies with Directive

2011/65/EU updated from 2015/863/EU.

PAGE 1
PRELIMINARY OPERATIONS Connect the cable to the Micro USB socket, and place the smart watch on the wireless charger. If the watch is on, it indicates that the charging is in progress. At the same time, you can check the battery charge status on the smart watch screen. Note: for recharging your Smartwatch, WIRELESS CHARGER must be powered by an adaptive charger or alternatively a charger with at least a 1A charge.
PAGE 2
FCC Warning Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.