User's Manual

If the threads strip due to improper installation or incoming Petals defective , the
Petals can disengage from the bike and /or break while under usage , which can
causes in serious injury to user.
NOTICE :
Left petal is reverse- threaded and the
Petals have labeled “ L “ OR “ R” for
distinguish.
The petal MUST be manual installed
straight into Crank arms and ensure
threads are aligned correctly.
First remove the nuts from the petals with Allen wrench.
Insert petals to crank arm and confirm that the Pedal is fully tightened with assigned
tools, please attention the screwing direction under figure.
Repeat with the other Pedal.
09
Step 2:
Attach Petals (Right and Left) to Frame Assembly.
Tools : Allen Wrench
Flat Wrench
10
If Nut loosen or slipped, the Seat
can be vibrated or disengaged while
under usage, which causes in
serious injury or accident to user.
Step 3:
Install Seat on Seat Slider.
Attach Seat Assembly to Seat Post.
Tools: Allen Wrench
Hardware: Seat; Seat Slide Lever;
Seat Post; Seat Adjustment Lever;
1
Attach Seat Post to Frame Assembly.
NOTICE :
Insert Seat Post vertically, make sure
Seat Post align with hole of Frame
Assembly.
2
Attach Handlebar Post to Frame
Assembly.
NOTICE :
Don’t break or twist cable while Untie
connector. Then pass data log-cable
through Handlebar Post by hand and
tighten Handlebar Adjust Lever.
3
1
2
3
NOTICE:
Insert Seat on Seat Slider vertically,
then Fix tightly with Allen wrench.
Place Seat Assembly on Seat Post
vertically, make sure Seat Slide Lever
align with hole of Seat Slider before
fix tightly.