User's Manual

17

If no devices show up, you may need to tap find devices again, or try
unplugging your device before repeating the previous steps.
7. Setup Device Page
The setup device page lets you take a picture of your device, name it and add
it to a room or a group. It will also automatically be added to a group with
similar devices (Smartplugs Group, Door Sensors Group)
Once you have named your device and completed any other choices
you may have wanted, you can tap the “Go to Dashboard” button to start
using your device.
18

8. Dashboard Page
The dashboard page shows your all of your devices and allows you to see
the device status as well as turn on and off powered devices.
In the top right of the screen is the Add button, tap this button to add new
devices, create groups/rooms and create scenes.
In the top left of the screen is your notification icon, tapping here will show
you the list of recent notifications from your devices.
Below the header bar is the status indicator, this area shows you how you’re
connected to your devices as well as how many devices in total are
registered to your account.
19

9. Navigation Wheel
The Navigation wheel is your primary way to get to the area of the app .you
care about at that instant. The wheel is normally half hidden and rotates with
the swipe of your finger. You can also drag up on the wheel to reveal the
whole wheel and select where you want to navigate in the app.
There are 6 sections for the wheel:
Top - The star takes you to your dashboard page
Top Right - The list takes you to your All Devices page
Bottom Right - The shopping cart takes you to the shopping page
Bottom - The Cog takes you to the settings page
Bottom Left - The puzzle piece takes you to the scenes page
Top Left - The Floor diagram takes you to your rooms/groups page
20

FCC Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1)This device may not cause harmful interference, and
(2)This device must accept any interference received, including interference
that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved
by the party responsible for compliance could void the user’s authority
to operate the equipment.
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: