User's Manual

6
Bottom View
Rear View
Charging Battery
The device has a built-in rechargeable battery. No extra battery installation is required.
Just charge the device when it indicates low battery.
To charge the battery, connect the device to any standard wall outlet via the DC-IN
port using the power adaptor. It takes about 5 hours to fully charge the battery. When
the battery is fully charged, the charge indicator at the left bottom should light up in
green. During charging, the indicator lights up in red.
Note:
a. You are strongly recommended to charge the battery immediately when the device
indicates the battery is lower than 15%!
b. You can operate the device even when it is being charged. But for extended battery life, it is
suggested NOT to use the device when it is charging.
c. It is recommended to charge the battery before you use the device for the first time.
d. For maximum performance, lithium-ion batteries need to be used often. If you don’t use the
device often, be sure to recharge the battery at least once per month.
Installing Memory Card
This device can read files directly from memory card.
To use a memory card, find the card s lot at the bottom of the device and then insert
the memory card into the slot in the correct orientation. To access the files stored in
the memory card, enter the Explorer mode by tapping the Explorer icon and select
g. Power-IN port connects to any standard electric source through the provided
AC adaptor.
h. SD Card Slot accommodates any standard SD memory card.
i. Earphone Port connects to stereo earphones (not provided with the unit.)
j. USB Port connects to a computer through the USB cable.
k. Power Button/Charge Indicator pressandholdtoturnonoroffthedevice;
briefly press to turn the screen on or off.
g
h
m
ll
l. Reset pin hole used to reset your
device if the device freezes.
m. Built-in Speakers
i
j
k