User's Manual

O Play/Pause
Press the
key to play the MP3/WMA file on the USB flash disk. The frequency is indicated on
the display. To pause during playback, press the
key. To resume, press it again.
O Previous/Next
Press the
key to play the previous track or press the key to play the next track.
O Switch Play Mode
This device provides two play modes: Normal and Random. You can switch the play modes by
pressing and holding the
key for a while.
O Switch Channel
Press the “+” or “-” key to switch the preset channels. When you switch to a certain channel, the
frequency is indicated on the display.
O Adjust Volume
Press and hold the
key to decrease volume, or press and hold the key to increase volume.
Note: When you use the LINE-IN function, the four keys except “+” and “-” key are unavailable. You
listen to the music by operating the control keys on the external audio player.
7 Technical Specifications
Item Description
USB Interface USB1.1 (USB2.0 Compatible)
FM frequency range 13 preset channels within 88.1~89.1MHz and 106.7~107.9MHz
SNR 85dB
Output Frequency 20HZ-20KHZ
Supported File MP3, WMA
Memory Card Support SD, MMC
Audio Source Memory card or audio player
Bit Rate 32Kbps—256Kbps
8 Notice
1. Operation voltage for the device is +12V. Too high or too low voltage could cause the device
damaged or failed.
2. For the sake of safety, please insert the USB flash disk before you plug the device into the car
cigar socket.
3. The device supports most USB flash disks except a few.
4. Frequency of the car FM tuner should be the same as that of the car MP3 player.
5. You’d better not pull out the USB flash disk during playback. Pause the playback first.
6. The progress may be slow when the USB flash disk stores too many audio files.
FCC NOTICE
1. This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.