Intelligent Wireless Router JHR-N805R JHR-N825R JHR-N916R JHR-N926R Quick Installation Guide VER: 0.0.
About this Guide Thank you for choosing JCG Wireless Broadband Router. As a cost-effective product, this Intelligent Wireless Router provides dedicated solution for small office, home and dormitory. It integrates a variety of wireless applications, such as wireless bridge model, AP model etc. It provides a wide range of data security protection; support WEP, WPA, and WPS Encryption method.
Quick Installation Guide You should configure the Router correctly to ensure the normal use of the Router. This chapter describes how to configure the basic functions of the Wireless Router. We will show the detailed configuration in the next chapter. 1 Configuring windows XP of the PC 1. Configure the IP address Click the start menu, select network connect, show in figure 1-1 Figure 1- 1 Right-click the local connection as shown in figure 1-2.
Figure 1- 2 Figure 1- 3 Double-click Internet Protocol (TCP/IP) will appear IP address page. If you choose to automatically receive the IP address and the DNS server address, the computer will be gain the IP address from the router (Show in figure 1-4).Of course, you can also choose manual-setting as shown in figure 1-5. Figure 1- 4 2. Figure 1- 5 Connect wireless network The wireless network will be connected after finished configuring the network parameter.
Figure 1- 6 Now, you can run the Ping command in the command prompt to verify the network connection between your PC and the router. If the result is similar to that show in figure 1-7, the connection between your PC and your router has been established. Figure 1- 7 If the link can not be established, please check the hardware connection between your PC and the router is normal, IP address is correct. 1.2 Quick Installation Guide Launch a Web browser (Internet Explorer 5.
Figure 1- 9 Click on Quick Setup the button, show in figure 2-10 , the router supports five connection type to connect to Internet.
② If you use the STATIC(fixed IP) connection, the Static IP settings page will appear, show in figure 1-12, enter the Static IP address, Subnet Mask, Default Gateway and DNS figure 1-12
③ If you use the PPPoE(ADSL) connection, the PPPoE settings page will appear, show in figure 1-13, please enter the user name and the password provided by your ISP. figure 1-13 Click on the Next button, show in figure 1-14.
Now, Quick Installation Guide is complete.
FCC WARNING This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
