User's Guide

USER GUIDE:
1. Open the phone holder
Set this product face up and open up the phone holder to 90
degrees from the side of the product. Stretch upwards, the holder
supports 360-degree rotation.
2. Bluetooth pairing
Take the remote controller out of the product,press its button for
3 seconds till the blue light flashes to show that the bluetooth is
working, then set your phone to pair up with the bluetooth "YMP",
when pairing successful, the blue light will be on all the time press
the remote controller botton for another 3 seconds to shut the
blue-tooth down.
3. Fix the phone
Rotate the phone holder till you can pull open the holder handle
and fix the phone steadily with it
4. Photograph
Open your camera App and set it ready for photographing, and
then you can use the remote controller to take photos freely.
5. Use the tripod
This product brings with a tripod, open the bottom cover and
pull out the tripod, then fix it on a flat surface, then you can
start to enjoy your photographing easily.
The bluetooth can be used
within 10 metres
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used
in portable exposure condition without restriction.