Use Instructions

7
Preparation for Flight
power switch
1.Boot up
Turn on the power of the remote control; turn on the power of
the drone (long press for 2 seconds to turn on/off)
2.Pair the Drone to the Remote Control
(1).After the remote control and the drone are properly loaded with
batteries, place the drone on a horizontal surface and turn on the
remote control power switch. At this time, the remote control power
indicator flashes red. Turn on the drone, the remote control will
beep twice to indicate that it is ready to pair, at this time the front
green lights and rear red lights flash.
(2).Slowly push the left lever of the remote control up to the top and
then down to the bottom. At this time, the remote control sends
out a pairing command and the power indicator light is always
green.
power indicator