User's Manual

1
3
4
2
Pac
king List
It includes one unit speaker
, one USB cable and one user manual.
Play / Pause : Press once
The device will turn itself o if it hasn’t been used in 5 minutes.
ON / OFF : Press and hold it for 3 seconds to turn it on or o
Light ashing : Bluetooth searching
Light stays on : Successfully paired
Turn on the Bluetooth on your device in setting to search
your nearby Bluetooth device;
Select device name to get paired
(It may take up to a minute to nd the device or sometimes
you may need to turn o and turn back on the bluetooth
function on your device to be able to nd the bluetooth name)
Product Operations
1. T
urn on both speakers by pressing and holding down the power
button for 3 seconds and make sure both of the speakers haven’t
been paired with any bluetooth device rst.
2. Quickly thrice press the power button on one or both speakers
and they should get paired in 15 seconds with a beep sound.
3. If the pairing is not successfully, turn o the both devices and
try it again by following the above instructions. When paired,
the main speaker indication light will ash and the other device
light will stay on.
4. To unpair the devices, thrice press the power button.
5. The two devices will be automatically paired once they have been
turned on If they have been paired before.
6. Press the power button once on either speaker will pause or
restart the playing.
Product Car
e Notices
1. It
’s recommended to use this product in a humidity environment
between 35% and 85% due to the product is made of natural
solid wood material.
2. A heavy drop may damage the wooden case and product itself.
3. Any natural wood grain or slight wood knot on the case is not
a product fault.
4. You may use a wet cloth to clean the wood case, but do not use
water to do the cleaning directly.
5. Please keep the product away from any long and direct sunlight
exposure as this may change the wood colour or cause other
damages to the wood case gradually.
6. Please only use 5V USB charging adapter to charge this product.
Any higher rated votage charging adapter may gradually damage
the product or shorten the battery life eventually.
5V Micro USB Charging Port
Approx 1.5-2 hours to be fully recharged;
Please fully charge it for rst time use;
Red light ashing: in charging;
Red light on: fully charged.
(You may connect the USB charging lead to any 5V USB charger
to charge the product, such as a smartphone charger or a
computer USB port).
Speaker
ON / OFF / TWS
Type C USB
5
Lamp
Lights
1
2
3
4
Please follow below steps to get them paired.
Product has TWS technology built in so it allows you to enjoy
the stereo quality sound when you have two speakers.
1. Keep the lamp side on top for
a few seconds the lamp will light up,
and when you put it down,
the lamp will turn o.
2. Double click the on/o button
to adjust brightness of the lamp.
TWS Pairing Instructions
Bluet
ooth V5.0
| |
Ba
tt
ery 800mAh
Input: 5V, 500mA
ø
Mono 45mm Speaker Dr
iver, 4Ω -5W
User Manual
The string can be revolve to different mode.
Lamp mode.
1. The sp
eak
er can be lay down
like a cannon which it’s good
for the sound come out.
2. This product has TWS function
you could connect two speakers
to play music at the same time.
Speaker mode.
Lay down the drum sp
eaker
Lamp and speaker both are
simultaneous working.
Lamp and speaker mode.
FCC Statement
Drum
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and
receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for
help
This device complies with part 15 of the FCC rules. Operation is
subject to the following two conditions (1)this device may not
cause harmful interference, and (2) this device must accept
any interference received, including interference that may
cause undesired operation.