User's Manual

BLUETOOTH SPEAKER & WIRELESS CHARGER
Main body
Wireless charger panel
Liftable anti-skid bracket
Volume +
Volume -
Type C port/ Charge port
BT on/off switch
Indicator light
Loudspeaker
Product Appearance and Function Introduction
低电压警报：滴警告声连续5次后关机。
Bluetooth speaker using
The red indicator light⑧ is on when charging, and it’ll off when full charged.
Turn on the power switch⑦, Then search for Bluetooth, the indicator light⑧
flashes once per second.
Choose the Bluetooth device(Name: Y. Creator)
After the Bluetooth device pairing, the indicator light⑧ flashes once per 2 seconds
with a pairing sound.
Low voltage alarm: The drop warning sound for 5
consecutive times, then the power be turned off.
How to use
Product type: Bluetooth Speaker & Wireless Charger
Function: Wireless charge, Bluetooth play
Bluetooth Version: Bluetooth v5.0
Distance: 20m (Depending on environmental factors and
connected Bluetooth devices)
Charging capacity: 800mAh/3.7V
Built-in battery: Li-ion battery
Output power: 3W
Wireless charger version
Wiewless charger: A2DP v1.3, AVRCP
Input: DC5V=2.0A9V1.5A 12V1.5A
Output: DC5V-1.0-1.5A9V1.0A12V0.85A
Power: 5W75W10WMax)
Charging distance: 2-8mm
Overvoltage protection, overheat protection, overcurrent protection,
FOD foreign matter detection
Operating temperature: 0~45°C
Dimensions: 72X72x82mm
Net Weight: 270 g
Contents of Package
Common Problem & Solutions
Bluetooth speaker & wireless charger----------------------------------1 pc
Type C USB cable-----------------------------------------------------------1 pc
User manual-------------------------------------------------------------------1 pc
Problem Solutions
Failed to
connect
for many times
Low sound or
sound
distortion occurs
1.Check if the speaker is in searching state,
or just restart it.
2.It is difficult to search when there are too many
devices. Please turn off other BT devices.
1. Check the volume of BT device and adjust it
to a suitable volume.
2. Low voltage, please charge it.
Bluetooth
Bluetooth
滴-滴-滴
指示灯
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to
operate the equipment.