User's Manual

2
 If you turn the Remote off , the data transfer of Dongle will be disconnection and access to the link mode. The
Satus LED flash 10 seconds as the frequency 1Hz, if the connection has been lost in the 10 seconds, the Status
LED will be off and Dongle access to Sleeping Mode.
●Data transfer mode：Status LED flash as frequency 1Hz(On 100ms Off 900ms)indicating the data link status.
●Registration mode：Status LED flash as frequency 2Hz
 The Status LED is off when the Dongle un-link in the Sleep Mode ,press the Comb Key,the Status LED flash as
the frequency 2Hz indicating the Dongle access to registration mode, if the connection with Remote has been
lost in 10 seconds ,the Status LED will be off and the Dongle access to Sleeping Mode
 After enter into the data mode, Press the Comb Key located on the Dongle and keep 4 seconds， When the
Status LED flash as frequency 2Hz indicating the Dongle enter into the registration mode and waitng the new
registration，if the connection with new Remote has been lost in the 10 seconds , the Dongle will enter into the
Sleeping mode。
● Low Power status
：The Status LED will begin to flash as frequency 4Hz indication
the voltage be in under 2.3V (2 battery)；When the voltage down to 1.8V(2 battery)，recommended that more
replacement batteries to ensure that the products of normal function.
● If Wii Nunchuk un- insert to the end of Dongle,the Status LED will flash as frequency 5 Hz , when Dongle did not
detect insertion Wii Nunchuk in 30 sec, Dongle will enter into sleeping mode.
4. When the Wii Nunchuk inserted to the Dongle, do not swing 3D-VR, this action can be ensure the WiiNunchuk to normal
operation. If the Wii Nunchuk occur the abnormal status, plug WiiNunchuk to reset the action.
Remote in Wii Remote Control
1. Compatible with the Wii Remote Control connector specifications
Compatible with the corresponding function of Wii Remote Control
◆Support a Connect LED display
●Connect line mode：Connect LED flashes as frequency 1 Hz
 Remote wait for a connection with the Dongle .
 After the connection completed , then enter into the data transfer mode
 When the disconnection between Remote and Dongle , Remote will enter into the connect line mode
automatically, and wait for a connection with the Dongle.
●Data transfer mode：
1. When Dongle be in static, Connect LED On 100ms Off 900ms to show that the data connecting line status.
2. When a button output of the Dongle, Connect LED flashes quickly to show that the data connecting line status.
● Registration mode:
Remote access to the registration mode, Connect LED flashes as frequency 2 Hz and Start the registration
with the new Dongle
■Connect line mode operation instruction: