Operation Manual

STEERING WHEEL CONTROLS
1. Connect the positive pole of the original steering wheel to the KEY(White) line
of the machine plug.
2. Connect the negative pole of the original car steering wheel button wire to the
GND(Black) wire of the machine plug.
3. In the “settings” interface, find “Steer” and enter.
4. Enter the steer and press the button to
learn. After the learning is successful, click the “OK” button on the page.
After saving, you can use the buttons on the original steering wheel to control
the machine.
Learning method: press and hold a button on the steering wheel of the original
car without letting go, find the button icon corresponding to the function of the
button on the steering wheel of the machine. Click this icon to change the color,
indicating that the button has been successfully learned, according to the same
The way you can learn other buttons. After all the keys have been learned, click
the “OK” button on the page to save the settings. If you need to relearn,
please click the "RESET" button on the page and then re-learn.