OPERATION MANUAL CAR MP5 PLAYER WITH 7 INCH HD DISPLAY PANEL FM RADIO RECEIVER BT MIRRORLINK
Before installation Thank you very much for purchasing and using our products, when you receive the product, please do not take the product directly to the car for installation, because the product is in the after a long journey, it may affect the product. Please try the machine before installing. Test method: Take the machine to the battery of the car and test it.
BASIC PARAMETERS Operating Voltage DC12V Maximum Current 15A Operating Temperature -10~+60 ℃ Screen Size 7 Inch Screen Resolution 800*480 System Windows CE Output Power 60W x 4 BT Function Ver:4.
PANEL COMPONENT DESCRIPTION Remote receiving window BT call microphone Previous Power & Mute Next Volume & Mode TF card port Reset AUX port USB port CVBS input Radio antenna Reversing video input Video output 2 Right audio output Video output 1 Left audio output Fush 10A~15A REAR INTERFACE DESCRIPTION
BT call microphone
REAR INTERFACE DESCRIPTION A B Red B Black ACC(Ignition Switch +12V) GND(Ground wire B-) White Yellow KEY(Steering wheel controls) + B+(Power Supply +12V) Gray REVERSE Green A Green/Black White White/Black Rear Left Speaker+ Rear Left SpeakerFront Left Speaker+ Front Left Speaker- Gray Front Right Speaker+ Gray/Black Front Right SpeakerPurple Rear Right Speaker+ Purple/Black Rear Right Speaker- -
Reverse/Back ( Gray "PARKING" ) S8 S8
2. Find the “About phone” and click Enter. Click on the “Build number” continuously until the phone screen displays “You are already a developer”.
3. Go back to the “System” interface, find “Developer options”, and click Go to find “USB debugging” and turn this feature on.
4. Connect the phone and the machine with the USB cable, and the dialog box “Allow USB debugging” will pop up on the phone. Click the “OK” button.
PHONE LINK FOR IPHONE * For iOS, X series and higher versions of mobile phones do not support mobile “phone link” with this machine. 1. Connect the machine and mobile phone with the original data cable. 2. When the phone pops up a dialog box: Trust This Computer? Select Trust to enter the interconnect mode.
STEERING WHEEL CONTROLS 1. Connect the positive pole of the original steering wheel to the KEY(White) line of the machine plug. 2. Connect the negative pole of the original car steering wheel button wire to the GND(Black) wire of the machine plug. 3. In the “settings” interface, find “Steer” and enter. 4. Enter the steer and press the button to learn. After the learning is successful, click the “OK” button on the page.
COMMON PROBLEMS AND SIMPLE TROUBLESHOOTING 1> Unable to boot normally --- Reason for not booting 1. “Yellow” “Red” “Black” this 3 lines only connected 2 line of them, so it willnot start, it should be that the yellow line is connected to the positive pole, red line to the key control line, black to the negative pole, less connection or wrong connection does not boot. 2.
4> 5> Car audio with BT but it can't work BT to play the song 6> 7> 8>
CAME video input interface on the back of the unit. The red line coming out of the video line is connected to the reversing control line of the power line. 2. The camera is broken. If the lamp that is properly wired to the camera is not lit, it will be broken and replaced with a new one.
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
