Installation Instructions

一、Plane structure diagram: unit:MM
二、Product parameters：
Product
parameters
Wire diameter
Number of
turns
note
1 - 2
0.08*28P
14
Hot air
stranded
wire
三、The technical requirements：
1. Secure the ends and ends of the wires to prevent loose or broken wires
2. According to customer requirements, the excessively long wire shears are plated with
tin, and the depth of tin plating is 2±1MM
3. Point the appropriate white glue on the soft magnetic chip, stick the coil, and ensure
that the product surface is clean and tidy during the process
4. The soft magnetic chip with round hole, no damage
5. Additional procedure (according to customer's requirements) : install 7.7x2.0mm
magnet in the middle hole of the finished product, and attach 14mm round double-sided
adhesive to the back of the finished product, and then package