User Manual

2: Multi-function button (MFB) : Power on/power off/answer a call/end a call/reject a call/redial
last number/pause/voice dial/play/switching between lines (three way calling)
3: “</V-” button: Short press for Previous Track; Long press to decrease Volume
4: “>/V+” button: Short press for Next track; Long press to increase Volume
5: LED indicator (see below for function details)
6: Built-in microphone
7: 3.5mm Aux-in jack
8: Micro USB Charging port
Fonction of LED indicator
A. When charging
RED LED is on when the battery is charging.
RED LED is off when battery charge is finished.
B. When using the headphone
RED and BLUE LED blink alternately when the headphone is in pairing mode.
BLUE LED blinks every 3 seconds when there is no phone conversation.
BLUE LED gradually turns on and off during phone conversation.
RED LED blinks with sound alert when the battery has low power.
CHARGING THE BATTERY
The headset comes with a built in rechargeable battery. Before using it for the first time we
recommend you charge the battery fully. Only use the supplied USB Cord to charge the headset.
Please charge for 4 hours.
Connect the micro USB connector of the charging cable into the micro USB port on the side of the
headphone. Connect the other end of the USB cable to your computer’s USB port or to an optional
USB wall charger (not included)
The RED LED indicator light is illuminated.
The RED LED indicator light shuts off when the speaker is fully charged. (Approximately 4 hours).
OPERATION INSTRUCTIONS
SWITCHING ON/OFF
Switch ON : Press and hold the MFB for 2-3 seconds, until the LED flashes BLUE.
Switch OFF: Press and hold the MFB for 3-5 seconds , until the LED stops flashing.
PAIRING INSTRUCTIONS
You need to pair the headphone with your Bluetooth® enabled device (smartphone, tablet, mp3
player, computer, etc.) before enjoying the music wirelessly with the headphone.
Enter in pairing mode
Be sure that the headphone is in power off status first, press and hold the MFB for 3-5 seconds,
until red and blue led blink alternately. Then release the MFB button, the unit is now in paring mode.
Pairing the headphone with Bluetooth® devices
Make the headphone enter into pairing mode (please refer to above section)
After searched, select ”OE-BTHS01” in the device list on the Bluetooth® device.
If a password is asked, enter the “0000” and press ”connect” (only some Bluetooth® devices will
ask for a password)
When the connection is successful, beep sound will be heard and the BLUE LED will flash quickly
for a few times while paired.