Instruction Manual

3
1. Description of Terms
Host：The safety panel is the core of the whole house safety, hereinafter referred to as the host.
Out Arm：The host enters the alarm state after the accessories are triggered when it is in a monitoring
state.
Stay Arm：It refers to the mode of arming the host when the user is in the internal protection area of
the alarm system. In this protection mode, all peripheral protection areas in the system (such as
outdoor perimeter probes and window door sensors) are in a protection state, but internal protection
areas in the system (such as indoor infrared probes) would not be auto-arm. The insiders can move
automatically in this area without generating an alarm.
Disarm：It is only trigger the emergency key or 24-hour defense zone device to enter the alarm state
after withdrawal when the host releasing the monitoring state.
Remote control：The user can control the mode of out arm mode, stay arm, disarm and alarm by
remote when the remote when the remote control and the host are paired successfully.
Detector：The user can install detector at the special area after the detector has paired with the host
successfully.And the detector will immediately send an alarm to the host for processing when the
detector is set off. The common detectors include door sensor, infrared detector, smoke detector, gas
detector, etc.
Wireless siren：After finishing pairing, after the host triggers the alarm, it can trigger the wireless alarm,
and the alarm volume can be increased to the maximum.
Arm delay：The host must delay for a period of time before entering the outgoing arming state when
the user operates it to enter the outgoing arming state. So that the user can evacuate the monitoring
area in time.
Alarm delay：It would be delayed for a period of time when the host receives the alarm from the
detector. During the alarm delay, the alarm can be revoked using the user password.
Siren time：It refers to The time for the host alarm to sound, after which the alarm would stop
sounding.
User Password：Host withdrawal, accessory setting, security setting can only be operated after user
password verification. The user password defaults to 1234, and the user can customize the user
password.
System password：Device restart and recovery can only be operated after system password
verification. The default system password is 9876, and users can customize the system password.
Scramble PIN code：The user can be entered 5-8-digit Scramble PIN code. It can be recognized as
correct password only if it contains 4 consecutive correct passwords.
Local alarm：The host horn and wired alarm will be sounded when the host alarms.