Instruction Manual

19
8. The Table Abnormal Fault Handling
Failure
The Reason
The Solution
Wireless Remote
malfunction
1. The battery power is insufficient.
2. The shrapnel of the battery compartment. is in
poor contact or rusted.
3. The format is not paired with the host.
4. Mismatch with host wireless parameters.
5. 1、Replacing the battery of the same
model.
6. 2、Cleaning the rust and dirt of shrapnel.
7. 3、Re-pair with the host.
8. 4、Purchasing accessories of the same
9. type with technical parameters.
Door sensor
failure
1. The battery power is insufficient.
2. The shrapnel of the battery compartment. is in
poor contact or rusted.
3. The code is not paired with the host.
4. Mismatch with host wireless parameters.
5. The door sensor is too far away from the
magnet.
1. Replacing the battery of the same model.
2. Cleaning the rust and dirt of shrapnel.
3. Re-pair with the host.
4. Purchasing accessories of the same type
5. with technical parameters.
6. Installing door sensors and magnets close
to each other.
Infrared Motion
Detector failure
1. The battery power is insufficient.
2. The shrapnel of the battery compartment. is in
poor contact or rusted.
3. The code is not paired with the host.
4. Mismatching with host wireless parameters.
5. Infrared installation location is unreasonable.
1. Replacing the battery of the same model.
2. Cleaning the rust and dirt of shrapnel.
3. Repairing with the host.
4. Purchasing accessories of the same type
with technical parameters
5. Re-commission the equipment and adjust
the infrared installation position.
Host does not
alarm
1. The host is not in the protection state.
2. Improper installation of components and too
far away.
3. Accessory codes do not match.
1. Carrying out protection operation on the
host.
2. Adjusting the position of the components.
3. Re-code.
The host
receives
remote control,
the
door sensor, and
the infrared
distance
becomes shorter
1. The main power is disconnected and the
standby power is insufficient.
2. There is signal interference from the same type
of product around the product.
3. It occurs the trouble when host receiving
module.
1. Checking the power supply and restore the
power supply.
2. Checking the interference source and
dismantle it.
3. Communicating with customer service for
repair.
Door and window
switch failure
1. The door and window switch signals are
opposite.
1. Need to trigger the door open signal.
2. Accessories for non-certified equipment.