Operating Instructions

MAINTENANCE & CARE

General cleaning will help prolong the life and performance of your treadmill. Keep the unit

clean and maintained by dusting the components on a regular basis. Clean both sides of the

running belt to prevent dust from accumulating underneath the belt. Keep your running shoes

clean so that dirt from your shoes does not wear out the running board and belt. Clean the

surface of the running belt with a clean damp cloth.

➢ To better maintain the treadmill and prolong its life it is suggested that the machine be

powered off for 10 minutes every 2 hours and fully powered off whenever not in use.

➢ A loose Running Belt will result in the runner sliding off when running, while too tight of a

Running Belt will result in decrease to the motors performance and also create more friction

between the roller and running belts. The most suitable tightness for the belts is pulled out

50-75mm from the Running Board.

CENTERING THE RUNNING BELT:

Place the treadmill on level ground and set it at 3.5 mph to check if the Running Belt drifts

LUBRICATING THE TREADMILL

1.If the Running Belt moves to the

right, power off treadmill,then turn

the adjusting bolt on the right side

¼ turn clockwise.Then power on

the treadmill and run the treadmill

for a few minutes.Repeat this step

until it centers. Refer to figure A.

2.If the Running Belt moves to the

left, power off treadmill,then turn the

adjusting bolt on the left side ¼ turn

clockwise. Then power on the

treadmill and run the treadmill for a

few minutes.Repeat this step until it

centers. Refer to figure B.

3.Over time the Running Belt will

loosen. To tighten the belt,power off

the treadmill,turn the Left & Right

side adjustment bolt ¼ turn

clockwise,Then power on the

treadmill,check the tension of the

belt. Continue this process until belt

is at the correct tension. Make sure

to adjust both side equally to

ensure belt alignment. Refer to

figure C.

Note: If the Running Belt is too tight, to loosen the belt turn the Left & Right side adjustment

bolt ¼ turn anti-clockwise,check the tension of the belt. Continue this process until belt is at

the correct tension. Make sure to adjust both side equally to ensure belt alignment.