User's Guide

!
6. SSC Command Reference
Parameter
7.5. dhcp
Description
dhcp commands are used to enable or disable dhcp server/client.
Example
dchp󰲧-S󰲧[-o󰲧mode]
dhcp󰲧-E󰲧[-o󰲧mode]
dhcp󰲧-Q󰲧[-o󰲧mode]
Parameter
7.6. ip
Description
ip command are used to set and query the IP address of the network interface.
Example
ip󰲧-Q󰲧[-o󰲧mode]
ip󰲧-S󰲧[-i󰲧ip]󰲧[-o󰲧mode]󰲧[-m󰲧mask]󰲧[-g󰲧gateway]
Table 6-4. mac Command Parameter
Parameter Description
-Q Show MAC address.
-o mode
•
mode = 1: MAC address in STA mode.
•
mode = 2: MAC address in AP mode.
Table 6-5. dhcp Command Parameter
Parameter Description
-S Start DHCP (Client/Server).
-E End DHCP (Client/Server).
-Q show DHCP status.
-o mode
•
mode = 1 : DHCP client of STA interface.
•
mode = 2 : DHCP server of AP interface.
•
mode = 3 : both.
Xinyuan
! /1211
2022.11