Operating Instructions

1. Install the battery, pr ess ON key for 3 seconds (Figure 2), then press START, and the
electronicmeterstartstorecordthemotiondata.Ifnodataisdetected,thedatadisplay
window is always 0. When a signal input is detected, the TIME / COUNT / DISTANCE /
CALORIES
windowvaluewi llcountup;


图 2 
1.1 Inthebootstate,thefirstvalueofthefirstwindowoftheelectronicwatchwillflash,
theusercanpressUP health,setthemovementTargetdistance,pressSETtoswitchtothe
secondvalue,setinturn.AftersettingOK,pressSTARTJtostartCountermovement.
1.2  Inthebootstate,thefirstvalueofthefirstwindowoftheelectronicwatchwillflash.
Iftheuserneedstosetthemotiontargettime,PressDIS.TIMEhealth,youcanswitchtothe
time settingbar, the user can pressUP health, set the movementtarget distance Off ,press
SETtoswitchtothesecondbitvalueandsetitinturn.AftersettingOK,pressSTARTJtostart
moving(Figure3,graph4)
  
图 3图 4
1.3 Inmotion;pressMODE,switchTIME/500m;WATTS;switchone
functionpercalspre ss(Figure5)