User's Manual

added. For example, if 4 sensors were to be added to zone/group 01 through zone/group 15, it total 60
sensors in all. If 1 device is removed from a group that has 4 devices, then all 4 devices in the group will
be automatically removed, and each device(s) will have to be added again to the alarm host.
Enabling and Activating Smart Zone Function (After adding smart door/window sensor successfully)
Press _Set + Password + ENT _ then.
_91 + ENT + XX + ENT -------The alarm host will beep twice to indicate the smart zone function has been
enabled.( Note: The XX indicates group number of the defense zones, including zone 06 through 10.)
To activate smart zone function by putting the magnet (or smaller piece) and the emitting (or larger piece)
together to get closed when the host is in working status.
Note: 1. When arming the host, if the door/window with the smart door/window sensor installed is on, the
LED light of the corresponding zone will appear solid red, at the same time the host will beep
every 2 seconds within 30 seconds.
2. You can arm again to make a force arm.
3. If press “ESC” or wait the host to get out of arm operation automatically in 30 seconds. LED
light turns off to indicate unsuccessful arm.
4. If the smart zone function is not enabled and activated, it can only work as a general
door/window sensor.
FCC Statement
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
Note: The manufacturer is not responsible for ANY interference, for example RADIO or TV interference, caused by
unauthorized modifications to this equipment. Such modifications could void the user’s authority to operate the equipment.