User's Manual
30 / 42
Use 75%
ethyl alcohol
to clean the electrode surface and use clean towel to wipe it.
Do not wash with detergent or hot water.
Electrodes should be covered with the film when not in use. Keep it clean and restore it carefully.
6.3 Skin Care
Please check your skin condition before and after use. Slight redness is normal and it indicates the blood circulation is
faster in this area. Always add ample amounts of water to the area of skin that will be in contact with the electrodes.
6.4 Skin Irritation Prevention Advice
Use water to remove all makeup, unclean areas or oil from the skin.
Do not position the electrodes over an irritated area of the skin.
Remove hand’s hair will intensify conductivity. Electric razor or small size razor is recommended. If necessary, an
electric razor or a pair of scissors are recommended to trim the hair where the skin contact the electrodes. Shave
the night before. Do not shave and then immediately place the electrodes as it could cause discomfort.
If any skin irritation or allergy occurs, please stop using the stimulator immediately and follow doctor’s
instructions.
6.5 Product Service Life
The service life of the XFT-2003EA is 5 years. At the end of its life expectancy or the device ceases to continue working
please dispose of it in accordance with the local and national regulation.
6.6 Battery Safety
Please charge this device only with the original power adapter and do not use the device while charging. The XFT-2003EA
Nerve and Muscle Stimulator has a rechargeable battery that can only be replaced by an authorized representative.
Depending on usage the battery may need to be replaced every two to three years. The device needs about 3 hours to charge
when completely drained of power. The device is designed to work for 9 hours with a full charge.
7. Product Configuration
Stimulator
1 pc
Power Adapter
1 pc
Charging Cable
1 pc
User Manual
1 pc
Note: Product configuration is subject to change without notice.
8. Product Specifications
8.1 Stimulator Specifications
Stimulator Specifications
Dimensions
134*91*82mm