User's Manual

33 / 44
Please adjust the electrodes and press Play/Pause button again to restart.
5.3.5 Auto Off
The stimulator will auto off in 15 minutes if there is no operation.
6. Care and Maintenance
6.1 Maintenance for Stimulator

Always handle the stimulator carefully

Do not expose the stimulator to water, excessive heat or vibration.
 Keep it away from children.
 Use wet cloth with little neutral detergent or alcohol to clean stimulator’s surface.
 Avoid dropping the stimulator. Although this device is robustly designed damage may occur and cause the unit to
malfunction.
 Do not try to dismantle the stimulator, please contact the distributor or clinical facility where you purchased the device if
there is any problem.
6.2 Maintenance for the Metal Electrodes
 Integrated electrode can be used for a long time without exchange. Please keep them clean
 Use 75% ethyl alcohol to clean the electrode surface and use clean towel to wipe it after each use.
 Do not wash with detergent or hot water.
 Electrodes should be covered with the film when not in use. Keep it clean and restore it carefully.
6.3 Maintenance for the Hydrogel Electrodes

Electrode efficiency and durability depends entirely on the application, storage and care of the electrodes by the
well-informed XFT-2003E user. The durability of the electrodes is dependent upon keeping the hydrogel clean, hydrated
and free from foreign debris. Other factors relating to electrode durability are skin condition, wearing environment, usage
and climate. In all cases, the electrodes must be changed every 1 to 2 weeks (or reused around 30 times) to maximize
function and minimize the potential for skin irritation.
6.4 Skin Care
Please check your skin condition before and after use. Slight redness is normal and it indicates the blood circulation is faster in
this area. Always add ample amounts of water to the area of skin that will be in contact with the electrodes.
6.5 Skin Irritation Prevention Advice

Use water to remove all makeup, unclean areas or oil from the skin.

Do not position the electrodes over an irritated area of the skin.

Remove hand’s hair will intensify conductivity. Electric razor or small size razor is recommended. If necessary, an
electric razor or a pair of scissors are recommended to trim the hair where the skin contact the electrodes. Shave the
night before. Do not shave and then immediately place the electrodes as it could cause discomfort.

If any skin irritation or allergy occurs, please stop using the stimulator immediately and follow doctor’s instructions.